Table of Contents
Advertisement
Follow this procedure to install the Battery Backup Unit (BBU):
1
Remove the ACM from the enclosure by loosening the two ACM
screws and using the handle, slide the ACM out of the enclosure.
2
Lay the ACM on a flat surface as in above.
3
Orient the BBU as shown.
Installing the BBU
BBU Connector
Tabs
BBU
4
Feed the BBU cable through the hole provided and connect it to
the BBU connector.
5
Press the BBU into position and secure it by ensuring the four tabs
"click" into place.
6
Replace the ACM in the enclosure and tighten the ACM screws to
complete the installation.
Feed cable through
hole provided and attach
to the connector
Tabs
105
Advertisement
Table of Contents
