Indesit MSZ801DF Service Information page 38

M. DEFROST HEATER (See K for testing purposes)
1. Remove the components as in E, F, G and H.
2. Disconnect the two connections to the heater.
3. Remove the components as in K.
4. Push the heater upward out of its retaining clips, the clips can now be removed completely and the heater
withdrawn from the evaporator.
N. THERMAL CUT-OUT
1. Remove the components as in K1 to 4, to gain access. Note: The thermal cut-out is supported by a plastic
moulding at each side and is located at the top of the evaporator pipe. The plastic moulding must always
be positioned in this way. NOTE: The pipe that the cut-out and plastic support is mounted to must be 30
mm above the top fi ns of the evaporator.
P. COMPRESSOR HOUSING COVER PANEL
1. Remove the hex head screw securing the cover.
2. Keep the panel upright and manoeuvre upward to release from two locating plates at the bottom.
Note: This can be awkward because the cover has a lip that fi ts under the rear of the appliance.
Q. COMPRESSOR TERMINAL BOX
1. Cover pushes downward to fi t. It can be removed by applying pressure in an upward direction at the
lower edge of the black cover, just above the cable entry position.
2. Release the cable clamps.
3. Prise the PTC and overload assembly from the compressor.
R. SOLENOID VALVES
1. Remove the component as in P above.
2. Located at the rear right hand side (DX).
3. Release 2 screws securing the valve assemblies to a base bracket.
4. Remove the water pipes as necessary.
S. PLASTIC EVAPORATION TRAY
1. Remove the components as in P and R above.
2. The tray can now be removed from the rear of the appliance.
T. CONDENSER FAN MOTOR
1. Release the 2 screws securing the lower plinth grille beneath the doors.
2. Disconnect the water pipe feeding the in-line connector below the freezer door.
3. Remove the compressor cover as in P above.
4. Release the screw securing the plastic frame of the condenser fan to the back of the appliance.
5. Disconnect the water pipe at the green solenoid.
6. Draw both water pipes through the plastic frame.
7. Disconnect the connections to the motor - This is best done at the module, see page 28.
8. Lay the plastic frame and motor over at the top toward the solenoid valves. Manoeuvre the assembly to
remove from the lower brackets and release.
Service Manual
SIDE-BYSIDE
Edition
2008.09.02
38
Language
English