Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
LEVELLING THE APPLIANCE
The refrigerator has two front and two rear wheels at the base of the
product on each side that can be adjusted (see Figure A), or four
wheels of which only the two front wheels can be
adjusted (see Figure B).
If the appliance seems unsteady or you want the doors to close easier,
adjust the appliance's tilt, following the instructions below (depending on
the model, as shown in the fi gures on the right).
1. Check the installation location to be sure you have at least 10 mm clea-
rance on all sides including the top.
2. Connect the appliance to the mains power supply.
3. Move the refrigerator into its fi nal position.
4. Open both doors and remove the plinth to locate the levelling bolts at
the left and right of the refrigerator base. The top bolt
(1) will adjust the rear wheel (if provided), and the bottom bolt
(2) will adjust the front wheel.
5. Use the wrench provided to adjust the levelling bolts. Turn the levelling
bolt clockwise to raise the appliance, or anti-clockwise to lower it.
It may take several turns of the levelling bolts to adjust the tilt of the
refrigerator.
Note: do not unscrew the levelling bolts too much when lowering the appliance as they could fall
out.
Aligning the Doors
If, after switching on the appliance and adjusting the refrigerator and freezer doors, the doors are misaligned, di-
sconnect the appliance from the power supply and adjust both doors as indicated in the following diagrams.
Service Manual
SIDE-BYSIDE
Edition
2008.09.02
48
Figure A
Figure B
Language
English
Advertisement
Table of Contents
