Table of Contents
Advertisement
APPLIANCE DIMENSIONS
APERTURE MEASUREMENTS
Cabinet Height = 1760 mm
Cabinet Height with doors = 1765 mm
Depth including door handles: 605 mm + 150 mm = 750 mm
Depth without doors = 605 mm
Depth without handles: 605 mm + 110 mm = 715 mm
WATER FILTER
1.
Locate the water fi lter cartridge cap below the freezer compartment door.
Rotate the cap counter clockwise to a vertical position and pull the cap and fi lter cartridge out through
the base grille. Note: Since there is water in the cartridge, some spilling may occur.
2.
Remove the cartridge cap by sliding it off the end of the old cartridge.
DO NOT DISCARD THE CAP.
3.
Take the new cartridge out of its packaging and remove the protective cover from the o-rings.
Make a note of the installation date in the space provided on the new cartridge.
4.
Slide the cartridge cap onto the new cartridge.
5.
With the cartridge cap in the vertical position, push the new fi lter cartridge into the base grille until it
stops. Rotate the cartridge cap clockwise to a horizontal position.
6.
RUN WATER THROUGH THE DISPENSER UNTIL THE WATER RUNS CLEAR (about 9-14 litres or 6-7
minutes). This will clean the system and clear air from the lines. Note: as air is cleared from the system,
water may spurt out of the dispenser.
Service Manual
SIDE-BYSIDE
(all measurements are approximate)
(WITH DOORS OPEN 90° AND FULLY)
Edition
2008.09.02
7
PLAN VIEW
Language
English
Advertisement
Table of Contents
