Indesit MSZ801DF Service Information page 27

Ice dispenser SANKYO (models MSZ80...; XBZ800 AE NF/HA)
SANKYO Ice maker (VL):
Supply voltage ( nominal ) :
Motor power dissipation :
Heater power dissipation :
Ice production per day :
Condition to start ice production:
Condition to stop ice production:
The ice cube extracting will be managed only by twisting (no heating element inside). The "Ice-Full" arm turns
every 2 hours in the down position (30°C). In this case the internal contact inside of the icemaker, gave a signal
to the main board. The signal means, that the ice production can go ahead. If the arm can't go complete down,
while the ice cube doesn't allow this, the feedback signal is missing and the ice production will be stopped.
ICE -WATER VALVE MANAGEMENT:
The icemaker water valve will be automatically controlled and driven by the Main Board!
The fl ow rate for the icemaker water valve is:
Opening time of the icemaker water valve is:
Ice vavle ALARM indication for opening time:
Water pressure range with fi lter cartridge:
Water pressure range without fi lter cartridge:
The SANKYO Icemaker can be only checked with the "Built-In Test routine !!
Service Manual
SIDE-BYSIDE
220 / 240 V AC; 50/60 Hz
8 W 12V
185 W
0,8kg
-10°C ambient temperature for min. 2 hour
-9°C temperature in the mould (ice-sensor)
1,51 litres per minute (quantity fi xed, not adjustable)
5 seconds = ~100cc (+/- 3cc)
< 20 seconds
2,07 bar till 8,27 bar
1,38 bar till 8,27 bar
Edition
2008.09.02
27
Language
English