DENTSPLY AEU-25T Operation And Maintenance Instruction Manual page 12

9. PROGRAMMING A PRESET BUTTON WITH AN ENTIRE FILE SERIES:
1. Disable the Preset Memory Lock.
For instructions, read about the System
Setup Menu beginning on page 6.
2. Press and hold the desired Preset Button
for 1 second (until you hear a double
beep).
3. The display will show:
ACCESS FILE LIBRARY?
1=yes, 2=no, 3=esc
Press Button #1 to access file library.
4. The display will show:
PATHFILE ALL
1=next, 2=ok, 3=esc
Press Button #1 repeatedly until the
desired file series is shown on the
display. See the Chart 3 on page 11 for a
list of available file series.
Example 1:
To go to the Protaper
press preset button #1 three times.
The display will then show:
PROTAPER UNIVERSAL
1=next, 2=ok, 3=esc
5. Press Button #2 to select the displayed
file series.
6. The display will show:
LOAD ENTIRE SERIES?
1=yes, 2=no, 3=esc
Press Button #1 to load the entire series.
10
®
Universal series,
7. The display will show:
USE DEFAULT HP?
1=next, 2=ok, 3=esc
NOTE: The default handpiece is the
handpiece that was shipped with the
Endo DTC ® , specified in Quick Start
Operation Section 2 on page 4.
• If you are using the default handpiece
with this file series, press Button #1 and
go on to step 8.
• If you are using a handpiece other than
the default handpiece, press Button #2.
i. The display will show:
1/8 TUL HANDPIECE or
1/8 AG HANDPIECE
1=next, 2=ok, 3=esc
ii. Press Button #1 repeatedly to cycle
through the available handpiece ratios.
When the displayed handpiece ratio
matches the handpiece ratio you are
using with this File Series, press Button
#2.
8. The Preset Button is now set with the
selected file series.
For Example 1:
The display will now show:
PROTAPER UNIVERSAL
PROTAPER S1 & SX
Pressing the Preset Button repeatedly will
cycle through the individual files in the
selected series.
9. When you have completed the customiza-
tion of the desired preset buttons, re-enable
the Preset Memory Lock to avoid
inadvertently entering the File Library during
a procedure. For instructions, read about
the System Setup Menu beginning
on page 6.