Reverse Beeper; Torque Warning Tone; Accessory Warning Tone; Sleep Mode - DENTSPLY AEU-25T Operation And Maintenance Instruction Manual

SYSTEM SETUP MENU - CONTINUED:

REVERSE BEEPER

1=on, 2=off, 3=esc
When the Reverse Beeper (BPR) feature is active,
an audible beep will sound when the handpiece is
rotating in the reverse direction. This is a system-
wide setting and is not saved on a Preset Button
when programming.
• To enable the Reverse Beeper feature, press 1.
• To disable the Reverse Beeper feature, press 2.
• To exit the System Setup Menu, press 3.
SAVE CHANGES selection will appear. Select 1
to save changes and exit or select 2 to reject all
changes and exit.

TORQUE WARNING TONE

1=on, 2=off, 3=esc
When the Torque Warning feature is active, a
chirping warning noise will be audible when the
torque level reaches approximately 75% of the
selected torque limit. This is a system-wide setting
and is not saved on a Preset Button when
programming.
• To enable the Torque Warning Tone,
press 1.
• To disable the Torque Warning Tone,
press 2.
• To exit the System Setup Menu, press 3.
SAVE CHANGES selection will appear. Select 1
to save changes and exit or select 2 to reject all
changes and exit.

ACCESSORY WARNING TONE

1=off, 2=on, 3=esc
When the Accessory Warning feature is active, a
warning tone will be audible when a GT Accessory
file or ITR Emulation Accessory file is in use. This is
a system-wide setting and is not saved on a Preset
Button when programming.
• To disable the Accessory Warning, press 1.
• To enable the Accessory Warning press 2.
8
• To exit the System Setup, press 3.
SAVE CHANGES selection will appear.
Select 1 to save changes and exit or select
2 to reject all changes and exit.

SLEEP MODE

1=on, 2=off, 3=esc
After 20 minutes of inactivity, the Endo DTC
will enter Sleep Mode to conserve power. In
Sleep Mode, the lighted Console LCD display
will turn off and the green LEDs above the
CAL, FWD/REV, and MAX buttons will blink
once every second.
To resume normal operation when the Endo
DTC ® is in Sleep Mode, press any button on
the console or press the foot control.
This is a system-wide setting and is not saved
on a Preset Button when programming.
• To enable the Sleep Mode, press 1.
• To disable the Sleep Mode, press 2.
• To exit the System Setup, press 3. SAVE
CHANGES selection will appear. Select 1 to
save changes and exit or select 2 to reject
all changes and exit.
7. POWER SWITCH:
Controls power on/off to console. On the
switch, the on position is represented by a
'1' and the off position is represented by a
'0'. When the AEU-25 is turned on and not
in Sleep Mode, the Console LCD Display
will light.
®