Operating Procedures; Operation Flow; Preparation For Measurement - Nidek Medical AR-600 Operator's Manual

OPERATING PROCEDURES

§ 4

4.1 Operation Flow

Power ON

4.2 Preparation for Measurement

Measurements
→ 4.3 AR (Refractive Power) Measurement (p. 4-6)
→ 4.4 PD (Pupil Distance) Measurement (p. 4-8)
5. PRINTOUT
Power OFF
(Determine final prescription by subjective refraction.)
4.2 Preparation for Measurement
1. Turn ON the power switch.
The display panel indicates as shown below.
On the TV monitor, you will see the target and
Min. pupil mark in the center, Cylinder mode
indication on the top right, and measuring count
on the bottom left.
NOTE
• "ERR" appears on the TV monitor if the power is turned ON on condition that the
printer paper roll is not set in the printer housing.
To delete "ERR" indication, set the printer paper roll and turn the power ON again.
(p. 4-1)
(p. 5-1)
Target Min. Pupil Mark Cylinder mode indication
Measuring count