Acer NV5814U Quick Start Manual page 52

EN301893 - Broadband Radio Access Network, 5GHz high performance RLAN, harmonized EN covering essential
requirements of article 3.2 of R&TTE directive.
EN62311 - Generic standard to demonstrate the compliance of low power electronic and electrical apparatus
with the basic restrictions related to human exposure to electromagnetic fields.
This product must be used in strict accordance with the regulations and constraints in the country of use. For
further information, contact the local office in the country of use.
List of applicable countries
EU member states as of March 2009 are: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, The
Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden and United Kingdom.
M P
ODIFICATIONS TO THE RODUCT
CE Marking
Gateway cannot be held responsible for unauthorized modifications made by the user and the consequences
thereof, which may alter the conformity of the product with the CE Marking.
Radio Frequency Interference
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment.
C R E
ONNECTIONS AND EMOTE ARTHS
PELV (Protected Extra Low Voltage)
To ensure the extra-low voltage integrity of the equipment, only connect equipment with mains-protected
electrically-compatible circuits to the external ports.
SELV (Safety Extra Low Voltage)
Every input and output of this product is classified as Safety Extra Low Voltage.
Remote Earths
To prevent electrical shock, connect all local (individual office) computers and computer support equipment to
the same electrical circuit of the building wiring. If you are unsure, check the building wiring to avoid remote
earth conditions.
Building Supply
Only connect the equipment to a building supply that is in accordance with current wiring regulations in your
country. In the U.K., these are the IEE regulations.
P S C
OWER UPPLY AND ABLES
Power Supply
The power supply socket-inlet and socket-outlet (if equipped) are classified as Hazardous Voltage.
You must unplug the power supply cord and remove the battery to disconnect the equipment from the power
supply. In that aim, the socket-outlet should be installed near to the equipment and should be easily accessible.
Input rating: Refer to the rating label on the bottom of the computer and ensure that your power adapter
complies with the specified rating.
Under no circumstances should the user attempt to disassemble the power supply. The power supply has no
user-replaceable parts. Inside the power supply are hazardous voltages that can cause serious personal injury.
A defective power supply must be returned to your dealer.
Power Cables and Plug
This Product requires a three-wire grounded power cord and plug. The plug only fits in a grounded power outlet.
Make sure the power outlet is properly grounded before inserting the plug. Do not insert the plug into a non-
grounded power outlet. Contact your electrician for details.
The cord length must not exceed 2.5 metres. To prevent electrical hazards, do not remove or disable the ground
contact on the power cord. Replace the power cord if it gets damaged. Contact your dealer for an exact
replacement. In Europe, the plug must be rated for 250 VAC, 10 amp minimum. The plug must display an
international agency approval marking. The cord must be suitable for use in the end-user country. Consult your
dealer or the local electrical authorities if you are unsure of the type of power cord to use in your country.
Cables
For cables which are not delivered with the Product in the computer's packaging:
The EMC performance of the system is guaranteed only if the cable and interface use efficient shielding.
Quick Start & Troubleshooting Guide
52 -