Table of Contents
Advertisement
Important information
5.1 Safety information
General recommendations
Read the safety and operating instructions before operating the device.
Retain safety and operating instructions for future reference.
Adhere to all warnings on the device and in the operating instructions manual.
Follow all instructions for operation and use.
Electrical Shock or Fire Hazard
To prevent electric shock or fire hazard, do not remove cover.
No serviceable parts inside. Refer servicing to qualified personnel.
Do not expose this apparatus to rain or moisture.
Modifications to the unit
Do not modify this equipment without authorization of the manufacturer.
Preventive maintenance
With the monitor disconnected from mains perform the following periodical check:
•
Check the integrity of the power cord and inspect its routing, so that it is not under the risk of being
punched or cut.
•
Check the integrity of the Protective Earth connection.
•
Clean the area around the power plug, dust and liquids may result in fire.
•
Clean the ventilation slot of the monitor, dust can obstruct the air flow and cause temperature increase of
the electronics.
General recommendations:
•
Keep the monitor clean to prolong its operational lifetime.
•
LCD panel performances may deteriorate in the long-term. Periodically check that it is correctly operating.
•
Periodically check the tightness of the VESA mount screws. If not sufficiently tight, the monitor may detach
from the arm, which may result in injury or equipment damage.
Type of protection (electrical):
Monitor with internal power supply: Class I equipment.
Degree of safety (flammable anesthetic mixture):
•
Equipment not suitable for use in the presence of a flammable anesthetic mixture with air or with oxygen or
nitrous oxide.
•
The equipment shall not be operable when the air oxygen content is above 25%.
Non-patient care equipment
•
Equipment primarily for use in a health care facility that is intended for use where contact with a patient is
unlikely (no applied part).
•
The equipment shall not be used with life support equipment.
•
The user should not touch the equipment, nor its signal input ports (SIP)/signal output ports (SOP) and the
patient at the same time.
Mission critical applications
We strongly recommend there is a replacement monitor immediately available in mission critical applications.
28
K5902146 (451920612625) /04
Eonis
Advertisement
Table of Contents
