Removing Expansion Card From The Expansion Card Riser - Dell EMC PowerEdge R350 Installation And Service Manual

Figure 48. Installing the butterfly riser
Next steps
1. Install the air shroud.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

Removing expansion card from the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the expansion card
Steps
1. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
58 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
risers.
system.
system.