Removing The Drive From The Drive Carrier - Dell EMC PowerEdge R350 Installation And Service Manual

Figure 30. Installing a drive carrier
Next steps
If removed, install the front

Removing the drive from the drive carrier

Prerequisites
1. Follow the safety guidelines listed in the
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to remove the drive.
2. Lift the drive out of the drive carrier.
bezel.
Safety instructions.
Installing and removing system components 41