Installing The Microsd Card - Dell EMC PowerEdge R350 Installation And Service Manual

Figure 75. Removing the MicroSD card
Next steps
Replace the MicroSD cards.

Installing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: Ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the cards
during removal.
Steps
1. Locate the MicroSD card slot on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin end of
the card into the slot. To locate IDSDM, see the
NOTE: The slot is keyed to ensure correct insertion of the card.
2. Press the card into the slot to lock it into place.
80 Installing and removing system components
Safety instructions.
Before working inside your
System board jumpers and connectors
system.
section.