Dell EMC PowerEdge R350 Installation And Service Manual page 83

Figure 78. Installing the system board
Next steps
1. Replace the following components:
a. Trusted Platform Module (TPM)
NOTE: The TPM Module must be replaced only while installing new system board.
b. IDSDM module
c. Internal USB key
d. Heat sink
e. Processor
f. M.2 BOSS riser
g. Expansion card risers
h. Expansion cards
i. Connect the fan cables
j. Memory modules
k. Air shroud
2. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag by using System Setup
c. Update the BIOS and iDRAC versions. Re-enable the Trusted Platform Module (TPM). See the
Platform Module section.
4. If you are not using Easy restore, import your new or existing iDRAC Enterprise license. For more information, see the
Integrated Dell Remote Access Controller User's Guide available at
5. Follow the procedure listed in
section.
After working inside your
Restoring the system by using the Easy Restore
https://www.dell.com/idracmanuals
system.
Installing and removing system components
Manually
Upgrading the Trusted
.
83