Installing The Power Interposer Board - Dell EMC PowerEdge R350 Installation And Service Manual

2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the PSU or PSU
5. Disconnect the cables that are connected to power interposer board (PIB).
Steps
1. Pull the plunger up and move back to release hook.
2. Lift the PIB away from the system.
Figure 71. Removing the power interposer board
Next steps
Replace the power interposer

Installing the power interposer board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align the PIB board on the chassis with the edge of the hook.
2. Press the board and move it forward to hook it.
76 Installing and removing system components
Before working inside your
blank.
board.
Safety instructions.
Before working inside your
system.
system.