Dell EMC PowerEdge R350 Installation And Service Manual page 59

Figure 49. Removing an expansion card from riser
2. Install a filler bracket if the expansion card is not being replaced. Close the card retention latch.
NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 50. Installing filler bracket in the riser
Next steps
If applicable, install an expansion card into the expansion card riser.
Installing and removing system components 59