Intrusion Switch; Removing The Intrusion Switch Module - Dell EMC PowerEdge R350 Installation And Service Manual

Figure 16. Installing a cooling fan
Next steps
1. Install the air shroud.
2. Follow the procedure listed in

Intrusion switch

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
3. Lift the intrusion switch module out of the system.
30 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.