Table of Contents
Advertisement
M0094137-02
Install the Canister Fuel Filter
Illustration 90
1. Ensure that O-ring seal (2) is in position on fuel
filter (3). Lubricate the O-ring seal with clean
diesel.
2. Install fuel filter (3) to fuel filter base (1) and tighten
the fuel filter hand tight.
Note: Do not use a tool to tighten the fuel filter.
3. Close drain valve (4).
4. Turn the fuel supply valve (if equipped) to the ON
position
5. The primary fuel filter the secondary fuel filter must
be replaced at the same time. Prime the fuel
system, refer to this Operation and Maintenance
Manual, "Fuel System - Prime".
Fuel System Secondary Filter/
Water Separator - Drain
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Fuel System Secondary Filter/Water Separator - Drain
Illustration 91
Typical example
g06545420
1. Place a suitable container below filter. Open drain
valve (1) and allow fluid to drain.
2. When necessary, close drain valve (1) with hand
pressure only.
The procedure must be performed with primary fuel
filter drain. Refer to this Operation and Maintenance
Manual, Fuel System Primary Filter/Water Separator
- Drain for more information.
Fuel Tank Water and Sediment
- Drain
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
i06541262
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Fuel Tank
Fuel quality is critical to the performance and to the
service life of the engine. Water in the fuel can cause
excessive wear to the fuel system.
Maintenance Section
g06014499
i02348492
NOTICE
113
Hide quick links:
Advertisement
Chapters
Table of Contents
