ODB LCT60C Owner's Manual page 40

Figure 4.3d
One fitting on each bearing
Figure 4.3e
Figure 4.3f
ODB COMPANY
Maintenance Section
4.3 Lubrication, continued;
Lubrication Points, continued;
2.
3.
4.
5.
Boom Swivel Bearings (figure 4.3d): These
bearings are on most of ODB's model LCT600 and
LCT6000 after 1996. Grease the boom bearings
once every week with a multi-purpose moisture
resistant #2 grease.
PTO Bearing & PTO Shaft Fitting (figure 4.3e):
The PTO bearings should be greased after ev-
ery 50 hours of operation with a high grade, high
temperature lithium base #2 lubricant having an
operating temperature of 200 degrees F. Three
to five pumps with a hand operated grease gun is
sufficient. NOTE: Units manufactured after 2000
may not have a PTO bearing grease fitting. These
bearings are sealed and do not require greasing.
The PTO crossover shaft and linkage should be
lubricated with high temperature lithium base #2
lubricant after 200 hours of operation.
Hinge and Friction Points: Leaf vacuum opera-
tion and longevity can be improved by keeping
hinges and friction points lubricated. ODB recom-
mends that lubricaton be performed weekly. Use
SAE30 weight oil on hinges and a premium grade,
high temperature lithium based EP#2 grease on
friction points.
Hitch and Tongue (figure 4.3f):
The hitch and hitch ring should be checked and lu-
bricated daily to minimize wear. Apply grease and/
or SAE30 weight oil wherever applicable.
800-446-9823
40
LCT60C