ODB LCT60C Owner's Manual page 30

figure 3a
ODB COMPANY
Operating Section
3.1 Starting Engine, continued;
5. IMPORTANT: Do not operate the starter for more
than 30 seconds at a time. To do so may overheat
the starter. If the engine does not start the first
time, wait at least 2 minutes before trying again. If
the engine fails to start after 4 attempts, see the
trouble shooting section of the EOM and this man-
ual.
6. Turn the ignition switch all the way to the right, when
the engine starts release the ignition switch. It should
spring back to the first position.
7. IMPORTANT: If the ignition switch is released be-
fore the engine starts, wait until the starter and the
engine stop turning before trying again. This will
prevent possible damage to the starter and/or fly-
wheel.
8. After the engine starts, continue to hold the Murphy
Switch in until the oil pressure gauge reads at least 15
psi. The Murphy shut off switch will not allow the en-
gine to operate below this level. If the gauge does not
rise above 15 psi withing 5 seconds, stop the engine
and determine the cause. Normal operating oil pres-
sure is 50 psi with oil at normal operating temperature.
9. Check all gauges for normal engine opreration. If op-
eration is not normal, stop the engine and determine
the cause.
10. IMPORTANT: To assure proper lubrication, operate
the engine at or below 1200 rpm with no load for 1
-2 minutes. Extend this period 2 - 4 minutes when
operating at temperatures below freezing.
11. Watch the coolant temperature gauge. Do not place
engine under load until it is properly warmed up. The
normal engine coolant temperature range is 180 - 202
degrees F.
800-446-9823
30
LCT60C