Table of Contents
Advertisement
Pre-Installation Instructions
8014 Trotec Speedy 500
Laser Machine Requirements
1.3 Unloading of the crate and machine
The Speedy 500 is transported in a wooden crate.
A suitable fork-lift is required to unload from the courier vehicle and lift the machine off its pallet.
A powered screwdriver with cross-head bit is recommended for dismantling the wooden crate.
If possible keep the packaging in case the machine ever needs to be relocated or shipped for any
reason.
Perform the following steps to unpack the machine properly:
1
Dismantle top and rear of the crate.
3
Remove the front and side plates.
Open door on the front door of
5
Speedy500 (10mm Allen-Key).
Lift Speedy 500 with forklift on
7
indicated lifting points. Adjust rollers
and feet as necessary.
9
The machine must be allowed to stand for 24 hours before use.
13/12/2011
Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
Remove all tables and accessory found in the
2
slots on the rear.
Remove the transportation safety device.
4
Front: mid, back: left, right, mid (PSU-vat)
6
Follow the safety instructions!
Caution:
Lift only on indicated lifting points!
Lifting the machine on any
other point will cause
extensive damage.
Only lower the machine onto an even surface.
Remove the transportation safety device of the
8
x-axis.
techsupport@troteclaser.com
4 / 15
Advertisement
Table of Contents
