Srs Airbag System Servicing - Subaru 2007 Forester Owner's Manual

A8110BE.book 58 ページ ２００６年６月２３日 金曜日 午後１時３２分
1-58
Seat, seatbelt and SRS airbags
Side airbag sensor (Center pillar right-
hand side)
Side airbag sensor (Center pillar left-
hand side)
Side airbag module (Driver's side)
Side airbag module (Front passenger's
side)
Seatbelt pretensioner (Driver's side)
Seatbelt pretensioner (Front passen-
ger's side)
Seatbelt buckle switch (Driver's side)
Seatbelt buckle switch (Front passen-
ger's side)
Driver's seat position sensor
Front passenger's seatbelt tension sen-
sor
Front passenger's occupant detection
system weight sensor
Front passenger's occupant detection
control module
Front passenger's frontal airbag ON
and OFF indicator
All related wiring
If the warning light exhibits any of
the following conditions, there may
be a malfunction in the seatbelt pre-
tensioners and/or SRS airbag sys-
tem. Immediately take your vehicle
to your nearest SUBARU dealer to
have the system checked. Unless
checked and properly repaired, the
seatbelt pretensioners and/or SRS
airbags will not operate properly in
the event of a collision, which may
increase the risk of injury.
Flashing or flickering of the warn-
ing light
No illumination of the warning
light when the ignition switch is
first turned to the "ON" position
Continuous illumination of the
warning light
Illumination of the warning light
while driving

SRS airbag system servicing

When discarding an airbag mod-
ule or scrapping the entire vehicle
damaged by a collision, consult
your SUBARU dealer.
The SRS airbag has no user-ser-
viceable parts. Do not use electri-
cal test equipment on any circuit
related to the SRS airbag system.
For required servicing of the SRS
airbag, see your nearest SUBARU
dealer. Tampering with or discon-
necting the system's wiring could
result in accidental inflation of the
SRS airbag or could make the sys-
tem inoperative, which may result
in serious injury. The wiring har-
nesses of the SRS airbag system
are covered with yellow insulation
and system connectors are yellow
for easy identification.