Subaru 2007 Forester Owner's Manual page 287

A8110BE.book 14 ページ ２００６年６月２３日 金曜日 午後１時３２分
11-14
Maintenance and service
Guideline of coolant quantity (including cool-
ant in reservoir tank):
Non-turbo models:
MT. 7.3 US qt (6.9 liters, 6.1 Imp qt)
AT. 7.2 US qt (6.8 liters, 6.0 Imp qt)
Turbo models:
MT. 7.8 US qt (7.4 liters, 6.5 Imp qt)
AT. 7.7 US qt (7.3 liters, 6.4 Imp qt)
1
FULL
2
LOW
1) "FULL" level mark
2) "LOW" level mark
6. Pour the coolant and fill to the reservoir
tank's "FULL" level mark.
Be careful not to spill engine cool-
ant when adding it. If coolant
touches the exhaust pipe, it may
cause a bad smell, smoke, and/or
a fire. If engine coolant gets on the
exhaust pipe, be sure to wipe it
off.
Do not splash the engine coolant
over painted parts. The alcohol
contained in the engine coolant
may damage the paint surface.
600442
7. Put the radiator cap back on and tight-
en firmly. At this time, make sure that the
rubber gasket in the radiator cap is cor-
rectly in place.
8. Start and run the engine for more than
five minutes at 2,000 to 3,000 rpm.
9. Stop the engine and wait until the cool-
ant cools down (122 to 140°F [50 to
60°C]). If there is any loss of coolant, add
coolant to the radiator's filler neck and to
the reserve tank's "FULL" level.
10.Put the radiator cap and reservoir cap
back on and tighten firmly.
B00018