Activating And Deactivating The Alarm System; If You Have Accidentally Triggered The Alarm System; Arming The System - Subaru 2007 Forester Owner's Manual

A8110BE.book 13 ページ ２００６年６月２３日 金曜日 午後１時３２分
The alarm is triggered by:
Opening a door or the rear gate.
Physical impact to the vehicle, such as
forced entry (only vehicles with shock sen-
sors (dealer option))
Activating and deactivating
the alarm system
To change the setting of your vehicle's
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system (see "Disarm-
ing the system" in this section).
2. Sit in the driver's seat and shut all
doors and the rear gate.
3. Turn the ignition switch to the "ON" po-
sition.
4. Hold down the UNLOCK side of the
driver's power door locking switch, open
the driver's door within the following 1 sec-
ond, and wait 10 seconds without releas-
ing the switch. The setting will then be
changed as follows:
If the system was previously activated:
The horn sounds twice, indicating that the
system is now deactivated.
If the system was previously deactivated:
The horn sounds once, indicating that the
system is now activated.
NOTE
You may have the above setting
change done by your SUBARU dealer.
If you have accidentally trig-
gered the alarm system
To stop the alarm
Do any of the following operations:
Press any button on the remote trans-
mitter.
Cycle the ignition switch from the
"LOCK" to "ON" position three times within
5 seconds.

Arming the system

To arm the system using remote
transmitter
1. Close all windows and the moonroof (if
so equipped).
2. Remove the key from the ignition
switch.
3. Open the doors and get out of the vehi-
cle.
4. Make sure that the engine hood is
locked.
5. Close all doors and the rear gate.
Keys and doors
: Press to Arm the system.
: Press to Disarm the system.
Security indicator light
6. Briefly press the " " button (for less
– CONTINUED –
2-13
2
200815