Subaru 2007 Forester Owner's Manual page 44

A8110BE.book 15 ページ ２００６年６月２３日 金曜日 午後１時３２分
Rear seatbelts (except rear center
seatbelt)
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the
belt out slowly. Do not let it get twisted. If
the belt stops before reaching the buckle,
return the belt slightly and pull it out more
slowly. If the belt still cannot be unlocked,
let the belt retract slightly after giving a
strong pull on it, then pull it out slowly
again.
3. Insert the tongue plate into the buckle
until you hear a click.
4. To make the lap part tight, pull up on
the shoulder belt.
5. Place the lap belt as low as possible on
your hips, not on your waist.
100102
Seat, seatbelt and SRS airbags
Adjusting the rear seat shoulder belt
anchor height (window-side seating
positions only)
100103
The shoulder belt anchor height should be
adjusted to the position best suited for
you.
To lower the anchor height, push the re-
lease button and slide the anchor down.
To raise the anchor height, slide the an-
chor up. Pull down on the anchor to make
sure that it is locked in place.
Always adjust the anchor height so that
the shoulder belt passes over the middle
of the shoulder without touching the neck.
1-15
1
100104
– CONTINUED –