Toshiba RAV-SM304SDT-TR Service Manual page 155

No. Part name
1. Detachment
Inverter
3
assembly
1) Perform work of item 1 of
2) Take off screws of the upper part of the front
Be careful to check the inverter because high-
voltage circuit is incorporated in it.
3) Perform discharging by connecting
The electrolytic capacitor may not normally
discharge according to error contents and the
voltage may remain. Therefore, be sure to
discharge the capacitor.
For discharging, never use a screwdriver and
others for short-circuiting between
electrodes. As the electrolytic capacitor is one
with a large capacity, it is very dangerous
because a large electric spark will occur.
4) Take off screws (ST1T Ø4 × 8L, 2 pcs.)
5) Remove various lead wires from the holder
6) Remove the lead wire from the bundled part
7) Pull the inverter box upward.
8) Disconnect connectors of various lead
As each connector has a lock mechanism,
avoid to remove the connector by holding the
lead wire, but by holding the connector.
Procedure
cabinet.
• If removing the inverter cover under this
condition, P.C. board can be checked.
• If there is no space in the upper part of the
upper cabinet, perform work of 2 .
CAUTION
polarities by discharging resistance (approx.
100Ω, 40W) or plug of soldering iron to
terminals of the C14 (printed as "CAU-
–
TION HIGH VOLTAGE") electrolytic capaci-
tor (500μF) of P.C. board.
WARNING
WARNING
fixing the main body and the inverter box.
at upper part of the inverter box and wiring
holder at right side of the terminal block.
at left side of the terminal block.
wires.
REQUIREMENT
.
1
,
–
+
,
+
and
+ –
– 155 –
Remarks
Screws
Front cabinet
Inverter cover
Cord clamp
Screws
Plug of
soldering iron
Discharging
position
(Discharging
period
10 seconds
or more)
Inverter
assembly
Remove the connectors
with locking function by
pushing the part indicated
by the arrow mark.