Toshiba RAV-SM304SDT-TR Service Manual page 131

Change of lighting time of filter sign
According to the installation condition, the
lighting time of the filter sign (Notification of filter
cleaning) can be changed.
Follow to the basic operation procedure
1 2 3 4 5
( → → → →
• For the CODE No. in Procedure
• For the [Set data] in Procedure
data of filter sign lighting time from the following
table.
Setup data Filter sign lighting time
0000
0001
0002 2500H (At shipment from factory)
0003
0004
To secure better effect of heating
When it is difficult to obtain satisfactory heating
due to installation place of the indoor unit or
structure of the room, the detection temperature
of heating can be raised.
Also use a circulator, etc. to circulate heat air
near the ceiling.
Follow to the basic operation procedure
1 2 3 4 5
( → → → →
• For the CODE No. in Procedure
• For the set data in Procedure
setup data of shift value of detection tempera-
ture to be set up from the table below.
Setup data Detection temp shift value
0000
0001
0002 +2°C (At shipment from factory)
0003
0004
0005
0006
6
→ ).
3
, specify [01].
4
, select the setup
None
150H
5000H
10000H
6
→ ).
3
, specify [06].
4
, select the
No shift
+1°C
+3°C
+4°C
+5°C
+6°C
How to set up power saving mode
SAVE
1. Push
when the air conditioner is not working.
flashes. Indicates CODE No. "C2."
2. Select an indoor unit to be set by pushing
UNIT LOUVER (left side of the button).
Each time you push the button, unit numbers
change as follows:
Unit No.
1-1
The fan of the selected unit runs.
3. Adjust the power save setting by pushing
TIME
button changes the power level by 1% within
the range from 100% to 50%.
* The factory setting is 75%.
• This indication may not be true for types
other than 4-series outdoor unit.
4. Determine the setting by pushing
5. Push TEST button to complete the setting.
– 131 –
button for at least four seconds
Unit No. Unit No.
1-2
Unit No.
1-4
/ buttons. Each push of the
Setting of power level
in power saving mode
1-3
button.
SET