Before launching the SE Remote software, please see Chapter 3 Switcher Configuration
Utility for network setup information.
NOTE: It is not possible to run both the SEConfig and SE Remote software applications at the
same time.
SET Function
After the network connection between the PC and the HS-2850 is successfully configured,
you can then launch the SE Remote software on the PC. Locate SET function button which is
located just above the T-Bar. When clicked, a new window will open as shown left below.
This Settings window is used to match the software to the IP address of the connected HS-
2850 switcher.
Enter the switcher's IP address and then click the "Check" button to determine the switcher
model number which is then selected from the "Model" pull-down menu. Once configured,
click the OK button to shut down to "Settings" window and the SE Remote software should
be successfully connected to the HS-2850 as shown in the diagram below.
26