ESP Enterview VX Manual page 10

Swipe the new card/tag to be added, a double confirmation tone will be heard.
To add further cards simply swipe the next card/tag.
If the error tone is emitted (4x beeps), this indicates that this card/tag is already
registered
Press the ** key to exit programming mode.
Deleting user cards/tags
Enter programming mode.
Press 2 - a single confirmation tone will be heard
Enter the last 6 digits of the new card/tag to be deleted, a single confirmation tone will
be heard.
To delete further cards simply enter the last 6 digits of the next card/tag.
If the error tone is emitted (4x beeps), this indicates that this card/tag is already deleted
Press the ** key to exit programming mode.
Deleting User Cards/Tags by swiping
Enter programming mode.
Press 2 - a single confirmation tone will be heard
Swipe the new card/tag to be deleted, a double confirmation tone will be heard.
To delete further cards simply swipe the next card/tag.
If the error tone is emitted (4x beeps), this indicates that this card/tag is already deleted
Press the ** key to exit programming mode.
Deleting all user cards/tags
Enter programming mode.
Press 9 - a single confirmation tone will be heard.
Press 9 again - a double confirmation tone will be heard, once this tone stops the 'delete
all' command is complete.
Press the ** key to exit programming mode.
Setting the Unlock time
Factory default door open time is set at 05 seconds.
Enter programming mode.
Press 4 - a single confirmation tone will be heard
Enter the desired lock/relay operation time in a two digit format (01 to 99 seconds) - a
double confirmation tone will be heard.
The Unlock time is now changed.
Press the ** key to exit programming mode.
Changing the programming code
Factory default pin 4567.
Enter programming mode.
Press 8 - a single confirmation tone will be heard.
Enter the new 4 digit programming code and press # - a single confirmation tone will be
heard.
Re-enter the new 4 digit programming code and press # - a double confirmation tone will
be heard.
Press the ** key to exit programming mode.
10