Table of Contents
Advertisement
6.
Loosen (2) cap screws securing lower blade
guides (see Figure 44) and move blade
guides away from blade.
Figure 44. Two cap screws securing lower blade
guides.
7.
Release tension from blade by turning blade
tension nut (see Figure 45) counterclockwise
until blade moves freely.
Figure 45. Location of blade tension nut.
8.
Put on a pair of heavy leather gloves to pro-
tect your hands from blade teeth, then care-
fully remove blade.
-30-
Blade Guide
(1 of 2)
Blade Tension Nut
Installing Blade
1.
DISCONNECT MACHINE FROM POWER!
2.
Slide blade through upper and lower blade
guides and mount blade on upper wheel.
Verify blade teeth point down, as shown in
Figure 46.
Note: If teeth will not point downward in
any orientation, blade is inside-out. Remove
blade and twist it right-side-out.
Blade Teeth
Facing Down
Figure 46. Correct blade teeth orientation.
3.
Verify blade tension is released by turning
blade tension nut counterclockwise.
4.
Mount blade on lower wheel and verify blade
is centered on both wheels (see Figure 47).
PROPER TRACKING
Blade
Wheel
Centered
on Wheel
Figure 47. Correct tracking of blade on wheel.
Model T32304 (Mfd. Since 02/21)
Table
Blade Centered
on Wheel
Advertisement
Table of Contents
