Grizzly T32304 Owner's Manual page 19

6. Attach motor to motor mount with (4) M8-1.25
x 20 hex bolts, 8mm flat washers, 8mm lock
washers, and M8-1.25 hex nuts, as shown in
Figure 13.
Note: DO NOT completely tighten fasteners
until instructed to in Step 9.
Figure 13. Attaching motor to motor mount.
7.
With help from an assistant, lift saw body and
place on stand (see Figure 14). Secure with
(3) M8-1.25 x 20 hex bolts, 8mm flat washers,
and 8mm lock washers through elongated
holes on stand top.
Figure 14. Attaching saw body to stand top.
Model T32304 (Mfd. Since 02/21)
8. Fit V-belt into belt pulley groove, raise motor,
then fit V-belt into motor pulley groove (see
Figure 15).
x 4
Motor Pulley
Figure 15. V-belt installed on pulley grooves
(saw body removed for clarity).
9.
Press down on center of motor to tension
V-belt, then tighten (4) hex bolts to secure
motor. Make sure that motor does not twist
while applying pressure.
Note: When properly tensioned, belt should
deflect about
applied to belt mid-way between upper and
lower pulley (see Figure 16).
— If there is more than 1⁄4" deflection, loosen
(4) motor mount hex bolts, then repeat
x 3
Step 9 until properly tensioned.
Figure 16. Testing for
Belt Pulley
⁄ " when moderate pressure is
1
4
Belt Pulley
¼" Deflection
Motor Pulley
⁄ " V-belt deflection.
1
4
-17-