Table of Contents
Advertisement
10. Hold a straightedge close to the center of
both pulleys, and make sure straightedge
fully extends across rims of both pulleys, as
shown in Figure 17.
— If pulleys are parallel and coplanar,
straightedge will touch the top and bottom
rims on both pulleys. No further adjust-
ment is required.
— If pulleys are parallel but not coplanar,
straightedge will touch the top and bot-
tom rims on one pulley, but will not touch
either rim on the other pulley. In this case,
loosen (4) carriage bolts securing motor
mount, then re-position motor so straight-
edge touches the top and bottom rims on
both pulleys. Repeat Steps 9–10.
Belt Pulley
Touching Evenly
Motor
Figure 17. Checking pulley alignment with a
straightedge.
-18-
11. Connect motor power cord to power cord
receptacle on rear ON/OFF switch housing,
and secure to motor mount clamp hole (see
Figure 18) with cable holder.
Figure 18. Motor mount clamp hole location
(components removed for clarity).
12. Verify table lock location (see Figure 19), and
align open end of table slot with blade.
Table Slot
Open End
Table
Lock
Figure 19. Table lock located, and open table
slot aligned with blade.
Model T32304 (Mfd. Since 02/21)
Clamp Hole
Advertisement
Table of Contents
