Grizzly T32304 Owner's Manual page 21

13. Look down underside of table, as shown in
Figure 20, and line up grooves in table rails
with rollers on saw body. Slide table on first
group of rollers and make sure blade fits into
slot in table.
Table Slot
Figure 20. Example of aligning table with rollers
and table slot with blade.
14. Pull back on table lock to slide table over
second group of rollers.
Note: Table lock is spring-loaded and will
engage with hole in table rail to prevent table
from sliding.
15. Attach retention bracket underneath open
end of table and secure with (4) M6-1 x 10
cap screws (see Figure 21).
Cap Screw
(1 of 4)
Retention
Bracket
Figure 21. Retention bracket installed.
Model T32304 (Mfd. Since 02/21)
16. Pull back on table lock and verify table slides
back and forth, then lock table.
17. Attach (2) support brackets to table using (4)
M6-1 x 16 cap screws (see Figure 22).
18. Slide fence shaft through left support bracket,
then secure with (1) lock knob, as shown in
Figure 22.
19. Slide pusher shaft through right support
bracket, then secure with (1) lock knob (see
Figure 22).
Lock
Knob
(1 of 2)
Left
Support
Bracket
Figure 22. Location of fence and meat pusher
components (saw body removed for clarity).
x 4
Fence Shaft
Right
Support
Bracket
x 4
Pusher
Shaft
Cap Screw
(1 of 4)
-19-