Medc17 Dap 10-Pin 1.27Mm Converter - iSystem IC57163 User Manual

MEDC17 DAP 10-pin 1.27mm Converter

The MEDC17 converter and the pinout has been defined by Bosch.
Converter is connected at the end of the 10-pin 1.27mm Infineon DAP2 Wide D. Adapter
(Ordering code IC50163-2) or
acting as a pinout converter and is available for TriCore embedded targets featuring the
MEDC17 10-pin 1.27mm target debug connector. The adapter must be ordered separately.
The following pinout is valid on the target side:
Signal Signal
Direction Description
Ground
I/O DAP Data pin
Power on
I/O
Reset
Reference
I/O
Voltage
Signal Direction is described from the BlueBox perspective.
The pin next to the alignment pin is pin 10 and not pin 1!
Pin is marked with a number 1 directly on the converter target connector.
The converter connects to the target via a 10-pin 1.27mm connector, Samtec SFM-105-02-L-D-
A. A target should feature a matching part, for example Samtec TFM-105-02-L-D.
Ordering code
Infineon DAP/DAPE Active Probe
Signal Pin
1
GND 3
DAP1 5
nRESET 7
Vref 9
10-pin MEDC17 target pinout
IADAP10MEDC17
Pin Signal
2
4 DAP0
6
8 nTRST/DAPEN
10 DAP2
(Ordering code IC57163)
Signal Signal
Description Direction
DAP clock
Optional 3rd I/O
Data pin
Optional 2nd I/O
Data pin
O