Installation Guide; Mains And Earth Wiring - Pyronix ENFORCER Installation Manual

Hide thumbs Also See for ENFORCER:

Table of Contents

3 . I n s t a l l a t i o n G u i d e

NOTE 1: It is recommended that the Engineer menu is accessed prior to opening a powered Enforcer.

NOTE 2: If any new peripheral is installed (i.e. Modem, I/O board, Expander) it is recommended that the

Enforcer is powered down (mains and battery).

1. Slightly unscrew the two screws

located at the bottom.

NOTE: Do not fully unscrew at

these can be used as a 'hanger' to

the rear casing as shown in Step

It is important that the electrical earth connection is connected when connecting the 240V mains

supply to the Enforcer.

NOTE 1: Do not locate the mains cables next to internal cabling.

NOTE 2: Ensure that the Enforcer is not mounted on any metal surfaces.

NOTE 3: That the mains cables should not be internally 'looped' as shown. This may interfere with

the wireless antenna's. Where possible it is recommended that all mains cables should be installed

through the area nearest the mains terminals as shown above.

NOTE 4: If cable management is an issue, a spacer is available: ENF/SPACER-WE

Enforcer: Installation Manual

2. Unhinge the Enforcer from the top

and pull down to disconnect.

NOTE: Take extra care when

removing the front of the Enforcer as

modems, I/O boards etc may be

connected to the front.

Page: 5

3. Hang the front of the Enforcer

on the opening screws at the

bottom if required. Shown below.

Table of Contents