Bolting Down The Mx5600 - Nautilus Hyosung MX5600 Installation Manual

Installation Manual

Bolting Down the MX5600

► To bolt down the MX5600 using the Anchor Bolt Location Sheet (template), perform the
following steps:
1. Ensure that the surface where the MX5600 is to be placed is level so that the unit will
2. Place the anchor bolt location sheet where the MX5600 is to be installed.
3. Drill the correct diameter and depth holes at the locations marked on the sheet.
4. With the groove of the anchor bolt facing up, drive the anchors into the holes drilled in
5. Place the MX5600 on the bolt location sheet, matching the mounting holes of the unit
6. Firmly tighten the mounting bolts in the anchors.
not tip over when opening the upper/lower modules or the door.
step 3.
with the anchors.
© 2012 Nautilus Hyosung Inc. All Rights Reserved.
Chapter4. System Installation
4-3