Bolting Down The Mx7600 - Nautilus Hyosung MONiMAX7600 Installation Manual

Installation Manual

Bolting Down the MX7600

► To bolt down the MX7600 using the Anchor Bolt Location Sheet (template), perform the
following steps:
1. Ensure that the surface where the MX7600 is to be placed is level so that the unit will not
tip over when opening the upper/lower modules or the door.
2. Place the anchor bolt location sheet where the MX7600 is to be installed.
3. Drill the correct diameter and depth holes at the locations marked on the sheet.
4. With the groove of the anchor bolt facing up, drive the anchors into the holes drilled in
step 3.
5. Place the MX7600 on the bolt location sheet, matching the mounting holes of the unit with
the anchors.
6. Firmly tighten the mounting bolts in the anchors.
© 2011 Nautilus Hyosung, Inc. All Rights Reserved.
Chapter4. System Installation
4-3