Operation - Beurer LB 20 Instructions For Use Manual

– Make sure that your hands are dry when operating the device.
– Before putting the device into operation, check the cable for any damage. If the power cord
of this device is damaged, it may only be replaced with an original-equipment power cord
available from the specified service address.
– This device may only be operated with the voltage indicated on the rating plate.
– This device may not be operated with direct voltage.
– The device may not be tilted, moved or emptied while it is switched on or connected to the
power supply.
– Make sure that no water gets onto the cable or the plug.
– Always unplug the device when the tank is empty or the device is not in use.
– Never open the air humidifier before unplugging the power plug and disconnecting the appli-
ance plug from the device. This is considered improper use and presents a danger to life and
limb.
– Clean the device if it has not been used for a longer period.
– Always unplug the power plug before cleaning.
– Only clean the device in the specified manner (Point 4).
– Repairs to electrical appliances may only be carried out by specially trained persons. Incor-
rect repairs can result in considerable danger to the user.
– There may be a fire danger in case of improper use or use which is not compliant with these
operating instructions!

3. Operation

3.1 Putting into operation
This device is used to humidify room air. The air humidifier operates according to the evaporator
system: Two electrodes in the evaporator head heat the water with its electrical conductivity. There-
fore, distilled water may not be used.
The evaporator system prevents problems with bacteria, varying water qualities and lime emission
to the surrounding area.
– First remove all packaging and transport locks.
– Fill the tank as described in 3.2.
– Place the device on a firm, level, waterproof surface.
– First firmly insert the appliance plug in the appliance outlet and then in the socket outlet.
The humidifying output of the device can be changed by turning the output regulator.
With this regulator you can adjust the desired relative humidity.
Should you want a lower humidity, turn the regulator to the right toward "-".
For a higher humidity to the left toward "+". This enables you to adjust the relative humidity accor-
ding to your personal preference.
Please note that this air humidifier may also cause over-humidification of the room if you operate the
unit at a high setting and the humidity that is generated cannot escape from the room or if there is
already a high level of humidity. It is best to check humidity with a higrostat.
3.2 Filling water tank
caution! Danger! The device may not be filled as long as the appliance plug is connected! A
safety lock prevents the evaporator head from being turned and removed with the device con-
nected. Should the safety lock fail unexpectedly, never grasp the evaporator head on the underside
(by the electrodes), but instead immediately unplug the power plug!
To fill the tank, proceed as follows:
First disconnect the device from the power supply by unplugging the power plug and then the appli-
ance plug. Now turn the evaporator head counterclockwise as far as possible and remove it. Now fill
the tank with tap water. Never add salt or other substances to the tap water. When the color of the
fill level indicator changes to red, the maximum fill level has been reached and must never be excee-
ded (max. 3.8 quarts/3.6 liters). Insert the evaporator head in the tank again and lock it by turning it
7