Cleaning And Care - Beurer LB 20 Instructions For Use Manual

clockwise. First connect the appliance plug and then the power plug. The air humidifier immediately
begins to operate. After a few minutes steam exits from the device. If the water level drops below
the electrodes, evaporation stops. Please empty the remaining water before refilling the tank.
If the water level has dropped to a minimum, slight humming noises can result. These noises are
caused, because the electrodes still have slight contact with the water, however the water level is
no longer sufficient for evaporation. Either switch off the device or refill it with water as described.
3.3 Using aroma container
With the aroma container you can also release aromas and herbal essences into the air.
– Carefully fill the container with the desired substance. The container should not be filled more than
half full.
– Remove the container again after use and clean it of residues with warm water.

4. cleaning and care

Water contains lime and other particles. These are deposited in the evaporator and reduce the per-
formance of the device. In addition, a broad range of germs can accumulate
in water, especially on all wet surfaces.
For these reasons, regular cleaning is essential for the long enjoyment of your device. Please note
that more frequent cleaning is required for operation with water with a higher degree of hardness.
– Never use gasoline, kerosene, window cleaner, cleanser, furniture polish, thinner or other solvents
to clean your air humidifier.
– It is best to use water with a mild cleaning agent and a damp cloth to clean the surfaces. Wipe off
any cleaning agent residues once with clean water and then dry off the device.
Always make sure that the device is disconnected from the power supply and the electrodes have
cooled before cleaning, filling or transport.
Please note that the evaporator head may not be cleaned in the water tank. Therefore, place the
evaporator head in a container filled with water and vinegar (not higher than the "MAX" marking).
Allow the evaporator head to soak in the container for approx. one hour and carefully remove all
residues after cleaning. Carefully dry the evaporator head before remounting it in the tank. If you do
not intend to use the air humidifier for a longer time, store it after cleaning in a cool, dry place. Leave
the water tank open.
The electrode evaporator head is a wearing part, i.e. the electrodes are gradually used up. Metal
particles separated from the electrodes oxidize and accumulate in the water. The electrodes can
have a white (a sign of scale deposits -> they should be cleaned) or brownish coating. Both states
are normal and completely harmless. Should you require a new electrode evaporator head, you can
order it from the service address specified below.
5. storage
If you do not want to use your air humidifier for a longer time, e.g. during the summer, it is especially
important to observe the following information:
– Clean your air humidifier thoroughly, as described in 4.
– Make sure that all water is removed from the tank.
– Thoroughly dry the device.
– Pack the air humidifier in the original carton and store it in a cool, dry place.
8