Operation - Beurer LB 55 Instructions For Use Manual

Clean before using for the first time
For reasons of hygiene, we recommend rinsing the air humidifier, water tank and pad [4] thoroughly with
cold water before using for the first time. Then proceed as described in the "Cleaning the device" section of
chapter 8 "Cleaning and storage".
Filling the tank
Fill the tank when putting the appliance into operation for the first time or if the red indicator [A] is illuminated,
indicating that the water level is too low.
IMPORTANT
• Only ever use fresh tap water to fill the tank [8].
• Never put any additives into the water.
• Make sure that the tank catch [9] with seal on the base of the water tank [8] is tightly fastened before
putting the appliance into operation.
• Remove the cover [2] from the air humidifier.
• Pull the water tank [8] out of the air humidifier using the handles [7]. Unscrew the tank catch [9] from
the tank [8].
• Rinse out the water tank [8] with clean water.
• Fill the water tank [8] with cold tap water.
• Screw the tank catch [9] onto the water tank [8]. Place the water tank [8] in the air humidifier.
• Place the cover [2] on top of the air humidifier.
Air humidifier placement
Caution
Place the appliance so that the steam nozzle [1] is not pointing directly at a wall. The exiting moisture might
otherwise cause damage to walls, particularly to wallpaper.
• Place the air humidifier on a firm, even, water-resistant surface.
• Position the mains cable [11] so that the appliance cannot be knocked over.

7. Operation

IMPORTANT
Check the humidity of your ambient air regularly. Intensive continuous operation can cause the am-
bient air to become excessively humid. The relative air humidity should not exceed 60%.
Switching on the device
IMPORTANT
• Never switch on the air humidifier without the water tank [8] or steam tower [3].
• Insert the plug into the mains socket.
• Press the ON/OFF button [D] in order to switch on the air humidifier. The green indicator [B] is illu-
minated.
• Before the steam starts exiting: Rotate the steam nozzle [1] so that the steam exits in the required
direction.
• After a few minutes, the appliance starts to give off steam. The green indicator [B] is illuminated while
the appliance is switched on and connected to the mains.
Selecting the amount of steam
• Select the amount of steam using the steam button [C] .
Level 1: minimum steam (approx. 200 ml/h)
Level II: maximum steam (approx. 400 ml/h)
After a few minutes, the appliance alters the amount of steam generated.
17