Page 1
LB 37 EN Air humidifier Instructions for use...
Page 2
With kind regards, Your Beurer team Getting to know your device Humans spend a large proportion of their time indoors. For ideal ambient air, a humidity level of between 40 % and 60 % is recommended. This value is often not reached, particularly in winter, when cold, dry air enters living spaces that are being aired and is then warmed up.
Table of contents 8. Cleaning and maintenance ......7 1. Included in delivery..........3 2. Signs and symbols ..........3 9. Accessories and replacement parts ....8 3. Warnings and safety notes ......3 10. What if there are problems? ......9 4. Intended use ............4 11.
• Never hold or carry the device by the mains cable. • Do not clamp or pinch the mains cable. • Keep the mains cable away from hot surfaces. • Ensure that the mains cable and plug do not come into contact with water, steam or other liquids. •...
7. ON/OFF button with LED display 8. Aroma compartment Principle behind the LB 37 air humidifier 1. High-frequency vibrations release tiny drops from the surface of the water. 2. The fan draws in air through the aroma compartment on the side of the device.
Note • The immediate vicinity of the air humidifier can become damp. • Calcareous water can leave white deposits. • Do not place the device on the floor, but in a raised position (e.g. on a table or chest of drawers). • Position the device so that the mist outlet is not directed towards objects. •...
Switching off the device • Press the ON/OFF button ( ) 4 times. The LED lighting goes off. • Pull the plug out of the mains socket. Note In night mode, the air humidifier operates in level 2 with a lower evaporation output and no LED illumination to ensure undisturbed and therefore restful sleep.
• Tightly close the water tank using the screwed plug. Replacement items For replacement parts and additional items visit www.beurer.com or contact the corresponding service address in your country (according to the service address list). Replacement parts and additional items are also available from retailers.
10. What if there are problems? Problem Cause Solution No LED display The mains cable is not plugged in. Connect the plug. Red LED The water level is too low; the wa- Fill the water tank. ter tank is empty. No mist is produced The LED display lights red .
During the warranty period, should this product prove to be incomplete or defective in functionality in accordance with the following provisions, Beurer shall carry out a repair or a replacement delivery free of charge, in accordance with these warranty conditions.