Operation - Beurer LW 110 Instruction Manual

CAUTION:
• Do not add any essential oils or fragrances. If other additives are used, the plastic material may become
discoloured and damaged.
• Ensure the water level in the tub with inserted humidification discs never exceeds the lower edge of
the "MAX" marking on the inside of the tub.
Tip: The addition of a small volume of conventional washing-up liquid (e.g. 1 drop) breaks the water surface
tension and increases evaporation output.
Positioning the device
• Position the air washer in the vicinity of a heater to improve evaporation, in particular in large rooms
(do not exceed a max. temperature of 50 °C). Always ensure that the air inlet and air outlet remain clear
and that the air flows freely.
• Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard. You can clamp
the mains cable in the vertical ridge on the rear of the tub and lead it downwards.

7. Operation

Switch on the device using the "On/off" button
shows fan level 0 and the water fill level.
Select the fan speed using the fan button in the centre of the upper side.
Graphic displayed
The water level gauge indicates the tub fill level:
Graphic displayed
The air washer is switched off by pressing the "On/off" button
Regularly check the water level gauge during operation and refill the tub if necessary.
Fan level
Level 0, standby – fan off
Level 1, low
Level 2, medium
Level 3, maximum
Fill level
approx. 4.3 l to 7.25 l
Approx. 2.5 l to 4.3 l
Approx. 0.5 l to 2.5 l
Residual water in tub.
The tank must be refilled.
Device automatically switches off after 6 hours.
The device has switched itself off due to safety reasons. Clean and refill the
device before next use.
in the centre of the upper cover. The display lights up,
on the upper side.
8