Table of Contents
Advertisement
Vancouver
8. Insert the two threaded plates (11) through
the access holes into the roof brace, one on
each side of the vehicle.
9. Set the Vancouver in place. Do not install the
fasteners at this time.
10.Drill a 2 in. (51mm) hole approximately 2.5 in
(64 mm) behind the B-pillar and 2.5 in (64
mm) inboard of the left side of the vehicle.
Install edge protector (21) after protecting the
cut edge from corrosion.
14
Ram ProMaster
Advertisement
Table of Contents
Need help?
Do you have a question about the ProMaster Vancouver Standard and is the answer not in the manual?