Viewing Videos - JVC DLA-NZ9 Instructions Manual

Viewing Videos

Remote Control
3
2
This unit
1 3 2
26
MEMO
Make sure to remove the lens cover.
0
Connect the power cord, and ensure that the "STANDBY/ON" indicator
0
lights up in red.
During standby in the "ECO Mode", the "STANDBY/ON" indicator does
0
not light up even when the power cord is correctly connected.
In this case, cancel the standby mode by pressing any button on the
remote control unit, or use the A button on the projector unit when you
are turning on the power.
Turn on the power
1
Remote control: press the C [ON] button
Projector unit: press the A button
The "STANDBY/ON" indicator light switches from red (light off in
0
"ECO Mode") to green (light goes off after the unit starts up).
"STANDBY/ON" lights up (red)
In standby state
WARNING LIGHT
Choose the image to project
2
Remote control/projector unit: press the [INPUT] button to switch the
1
input
Play back the selected device to project the image.
0
To hide the image temporarily
Press the [HIDE] button on the remote control
The "STANDBY/ON" indicator light starts to blink in green.
0
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
0
The light source is turned off when the "Hide Mode" is set to "On" in the
0
OSD menu.
"STANDBY/ON" lights up (green)
When light source is starting up
WARNING LIGHT STANDBY/ON
STANDBY/ON AN BY/O DB
"STANDBY/ON" light off
When in "ECO Mode"
AN BY/O DB WARNING LIGHT STANDBY/ON