Table of Contents
Advertisement
Viewing Videos
Remote Control
3
2
This unit
1 3
2
MEMO
Connect the power cord, and ensure that the "STANDBY/ON" indicator
0
lights up in red.
Turn on the power
1
Remote control: press the C [ON] button
Projector unit: press the A button
"STANDBY/ON" lights up (red)
Choose the image to project
2
Press the [INPUT] button on this unit or remote control to switch the
1
input.
Pressing the button each time switches the setting in the following
0
sequence: "DisplayPort 1" " "DisplayPort 2" " "Dual"...
Play back the selected device to project the image.
0
* Refer to "Types of Possible Input Signals"P. 62.
To hide the image temporarily
Press the [HIDE] button on the remote control
The "STANDBY/ON" indicator light starts to blink in green. When "LED
0
Indication" is set to "Off", the indicator does not blink.
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
0
"STANDBY/ON" lights up (green)
In standby state
When LD block is starting up
WARNING
WARNING
LIGHT
STANDBY/ON
AN BY/O
DB
LIGHT
STANDBY/ON
AN BY/O
DB
25
Advertisement
Table of Contents
