JVC DLA-NZ9 Instructions Manual page 85

Video image does not appear
Check
Is the correct external input selected?
Is the power of the AV device or PC
turned on?
Is the AV device or PC properly
connected?
Are the correct signals being output from
the AV device or PC?
Is the cable in use an HDMI-certified
cable?
Is an intermediate device (AV amplifier,
divider, etc.) in use?
Is an old source device in use?
Is the input signal 2K (2048x1080)
24/25/30/60Hz?
3D images do not appear
Check
Do you see two images displayed side by
side?
Is an intermediate device (AV amplifier,
divider, etc.) in use?
Is the cable in use an HDMI-certified
cable?
Is the power of the 3D Glasses turned
on?
Are the 3D Glasses charged?
Are the 3D Glasses and 3D Synchro
Emitter too far away from each other?
Are the 3D Glasses synced?
Select the correct external input terminal.
Turn on the power of the AV device or PC and play the
video.
Connect the AV device or PC properly.
Set the AV device or PC properly.
Use an Ultra High Speed HDMI Cable (supports 48 Gbps).
HDMI cable may be directional and some HDMI cables
require external power. Please check the specifications of
the cable you are using.
Change the sequence of turning on the source device,
intermediate device and the projector. And after turning on
each device, ensure that the signal output is stable before
turning on the next device. If the intermediate device does
not support compressed video transmission, configure the
DSC setting under "HDMI EDID Setting" to "Off". If the
intermediate device does not support HDR10+, configure
the HDR10+ setting under "HDMI EDID Setting" to "Off".
Change the resolution setting of the source device. For
details on how to change the setting, please refer to the
instruction manual of the source device. Also, try the
"B" "C" mode settings under "HDMI EDID Setting".
If the input signal is 2K (2048x1080) 24/25/30/50/60Hz,
configure the "Mode" setting in "HDMI EDID Setting" to "B".
Set "3D Format" to "Side by Side"
Video images in the "Side by Side" format may not be
recognized automatically in the case of 3D video images.
Connect the source device to the projector directly, and
check whether there is any improvement in the condition.
If the condition improves, it is likely that this is not caused
by malfunction of the projector.
Use an HDMI-certified high-speed cable.
Also, use as short a cable as possible.
If you are using the PK-AG3 3D Glasses, turn on the power
manually.
Check the PK-AG3 battery of the 3D Glasses is charged.
Position them at an appropriate distance.
Check the 3D Glasses are synced.
Action
Action
Refer to
P. 26
P. 23
P. 23
P. 23
P. 23
P. 68
P. 68
P. 68
Refer to
P. 31
P. 23
P. 23
Check the
instruction
manual of the 3D
Glasses and 3D
Synchro Emitter.
85