Maintaining The Cabinet And Remote Control; Cleaning And Replacing The Filter - JVC DLA-NZ9 Instructions Manual

D-ila projector
Hide thumbs Also See for DLA-NZ9:
Table of Contents

Advertisement

Maintaining the Cabinet and Remote Control

Gently wipe off dirt on the cabinet with a soft cloth.
0
If it is extremely dirty, wet a cloth in water, wring dry and use it to wipe off the dirt, followed by wiping again with a dry
0
cloth.
Pay attention to the following as the cabinet may deteriorate in condition or the paint may come off.
0
Do not wipe with thinner or benzine
0
Do not allow prolonged contact with rubber or plastic products
0
Do not spray volatile chemicals such as insecticide
0

Cleaning and Replacing the Filter

Clean the filter every 2000 hours (more often in dusty conditions). Using a filter without cleaning may reduce the
brightness of the image. Dirt that enters the unit may also appear as shadows on the image.
Loosen the screws at the four corners and remove the cover
1
The screws cannot be removed from the cover. Do not try to remove the screws from the cover by force.
0
Remove the sponge filter
2
Use a vacuum cleaner to remove dirt from the sponge filter carefully
3
Restore the sponge filter to the original position
4
Restore the cover and fasten the screws at the four corners
5
MEMO
If the sponge filter is damaged and requires replacement, or if dirt gets into the unit, consult your authorized dealer
0
or nearby service center.
Sponge spacer
0
Product no.: J3K-0134-00
Sponge filter (gray)
Place the sponge filter under the tabs
2 3 4
1
83

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents