Recording > Recording settings ........................................................................................................................ 143
Technical Specifications ..................................................................................................................................... 455
Technology License Notice ................................................................................................................................. 458
NOTE:
If powered by a power adapter, the adapter should be properly grounded.
セキュリティ基準(新規則第34条の10)
「本製品は
電気通信事業者(移動通信会社、固定通信会社、インターネットプロバイダ等)
の通信回線(公衆無線 LAN を含む )
に直接接続することができません。本製品をインターネットに接続する場合は、必ずルータ等
を経由し接続してください。」
Status LED
Item LED status
1
Steady
red
Red
LED OFF
2
Steady
red
&
Green
Steady
red
&
Green
3
Red
blinking every 0.15 sec. &
every 1 sec.
4
Red
blinking every 0.15 sec. &
every 0.15 sec.
Hardware Reset
The reset button is used to reset the system or to restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the reset button with a paper clip or thin object. Wait for the Network
Camera to reboot.
Restore: Press and hold the reset button for at least ten seconds to restore system defaults.
Note that all settings will be restored to factory defaults.
blinking every 1 sec.
LED OFF
Green
blinking
Green
blinking
Description
Power on and system booting
Power off
Network normal (heartbeat)
Network failed
Upgrading firmware
Restoring default
VIVOTEK
User's Manual - 3