Table of Contents
Advertisement
11.10
Changing the Engineer Code
Enter
If an incorrect key is entered an error tone will be given and the function ended.
11.11
Programmable Outputs
11.11.1 Programmable Output 1
Enter
followed by
11.11.2 Programmable Output 2
Enter
followed by
Rins 181 Issue7
then
(Factory Set at 9999)
then
then
-
for following options:
0
OFF (programmable output 1 not used).
1
PIR remote LED enable.
2
PIR latch memory.
3
Output switch 5 secs.
4
Output switch reflecting setting and unsetting of panel.
5
Follow zone. Refer to 11.1121 for Zone allocation.
6
Follow line fail.
7
Follow kiss off.
-
for following options:
0
OFF (programmable output 2 not used).
1
PIR remote LED enable.
2
PIR latch memory.
3
Output switch 5 secs.
4
Output switch reflecting setting and unsetting of panel.
5
Follow zone. Refer to 11.11.22 for Zone allocation.
6
Follow line fail.
7
Follow kiss off.
The old Engineer Code - gives an audible acceptance tone
the new Engineer Code - gives an audible acceptance tone
the new Engineer Code again- gives an audible acceptance tone
Page 21
Advertisement
Table of Contents
Need help?
Do you have a question about the BUMBT!8 and is the answer not in the manual?
Questions and answers