Table of Contents
Advertisement
5. Select INSTALL.
6. After the driver is install, do an OS/2 shotdown.
7. Restart OS/2.
8. Open an OS/2 full-screen command prompt.
9. Insert the mach64 installation disk in the floppy drive and
type:
B: for A:)
OS2INST<enter>
10. Select INSTALL DEVICE DRIVER from the Main Menu.
11. Select IBM OS/2 from the list of applications.
12. Select UN-INSTALL OS/2 DRIVER then follow instruction
on the screen.
De-Installation Procedure - OS/2 Warp 3.0
1. Open the OS/2 System folder.
2. Open the System Setup folder and the Select Install object.
3. Select PRIMARY DISPLAY and bring up the Display
Driver Install panel.
4. Select the Video Graphics Array(VGA) driver and choose
OK.
The OS/2 Setup and Installation panel appears.
5. Select INSTALL.
6. Specify the VGA driver source directory and follow the
screen instructions.
7. When the VGA driver is installed. do an OS/2 shutdown.
Continue with the following steps if you wish to remove
mach64 files from your hard disk.
8. Restart OS/2
9. Open an OS/2 full-screen command prompt.
10 Type:
A:<enter>(For driver B. substitute B: for A:)
OSINST<enter>
Chapter 4 ¾ VGA REFERENCE
A:<enter>(For driver B. substitute
Advertisement
Table of Contents
